Global shipping available

Fiat Abarth 500 595 695 Rear Wiper Blade Delete

Fits: Fiat Abarth 500, Fiat Abarth 595, Fiat Abarth 695

Please note we will not take responsibility for any damage caused during or after installation. This part has been tested with daily use in rainy England for the past year and has been assembled by hand to ensure proper functionality.

Tools and materials

  • 10 mm socket
  • 5 mm Allen key
  • Trim tool
  • Adhesive (supplied)

Steps

  1. Step 1

    Using a 10 mm socket, remove the nut and lift off the rear wiper arm.

    Abarth 500 595 695 rear wiper arm on the tailgate glass, removed with a 10mm socket
    Abarth 500 595 695 rear glass with the wiper arm removed, spindle and washer jet left
  2. Step 2

    Open the tailgate and remove the interior trim. Pop out the plastic caps, then undo the single 5 mm Allen bolt holding the pull handle.

    Abarth 500 595 695 tailgate open showing the interior trim panel to remove
    Abarth 500 595 695 tailgate pull handle with its 5mm Allen bolt removed
  3. Step 3

    Remove the wiper motor by undoing the three 5 mm Allen bolts, then remove the grommet from the glass.

    Abarth 500 595 695 inner tailgate with the rear wiper motor and its three 5mm Allen bolts removed
  4. Step 4

    Clean the area around the hole in the glass so the adhesive bonds properly.

    Abarth 500 595 695 rear glass hole cleaned and ready for the blanking plug
  5. Step 5

    Apply the adhesive and insert the blanking disc, making sure you remove the protective film from the outside face.

    Close up of the flush black blanking plug in the Abarth 500 595 695 rear glass, fits 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 2022 2023 2024

Kits this guide covers