Audi A3 8V Rear Wiper Blade Delete
Fits: Audi A3 8V
Please note we will not take responsibility for any damage caused during or after installation. This part has been tested with daily use in rainy England for the past year and has been assembled by hand to ensure proper functionality.
Tools and materials
- 13 mm socket and ratchet
- T20 Torx bit
- Trim tool
- 10 mm socket
- Adhesive (supplied)
Steps
Step 1
Flip up the wiper arm cover, loosen the 13mm nut with a ratchet and remove the wiper arm.
Step 1 
Step 2
Remove the warning triangle from the tailgate trim, then remove the two T20 screws holding the interior panel.
Step 2 
Step 3
Using a trim tool, carefully unclip and remove the interior tailgate trim to gain access to the inside of the tailgate.
Step 3 
Step 4
Disconnect the washer line and unplug the electrical connector from the wiper motor.
Step 4 
Step 5
Remove the three 10mm nuts holding the wiper motor in place and lift the motor out. While you're here, it's a good idea to loosen the surrounding cables so they're out of the way.
Step 5 
Step 6
Apply the adhesive around the hole in the glass and insert the blanking disc. Make sure you remove the protective film from the outside face of the disc.
Step 6 
Step 7
Clean the glass and you're done.
Step 7 