Global shipping available

VW Polo AW Rear Wiper Blade Delete

Fits: VW Polo AW

Please note we will not take responsibility for any damage caused during or after installation. This part has been tested with daily use in rainy England for the past year and has been assembled by hand to ensure proper functionality.

Tools and materials

  • 13 mm socket
  • T20 Torx bit
  • Trim tool
  • 10 mm socket
  • Adhesive (supplied)

Steps

  1. Step 1

    Flip up the wiper arm cover, then remove the nut with a 13 mm socket and lift off the rear wiper arm.

    VW Polo AW rear wiper arm with the cover lifted to reach the 13mm nut
  2. Step 2

    Remove the four T20 screws: two inside the tailgate pull handles and two in the access holes in the trim panel.

    VW Polo AW tailgate trim showing the handle and access holes for the T20 screws
  3. Step 3

    Unclip and remove the interior boot trim, unplug the wiper motor, then remove the three 10 mm nuts and lift the motor out.

    VW Polo AW tailgate with the interior trim removed and the rear wiper motor exposed
  4. Step 4

    Apply the adhesive around the hole in the glass and insert the blanking disc. Make sure you remove the protective film from the outside face of the disc.

    VW Polo AW rear glass hole ready for the blanking plug after the wiper motor is removed
  5. Step 5

    Clean the glass and you're done.

    Factory Delete blanking plug bonded into the Audi A3 8V rear glass
  6. Step 6

    That's it, your rear wiper removal kit is installed.

    VW Polo AW rear three quarter view with the Factory Delete rear wiper removal kit installed

Kits this guide covers