VW Golf Mk7 Rear Wiper Blade Delete
Fits: VW Golf Mk7, VW Golf Mk7.5
Please note we will not take responsibility for any damage caused during or after installation. This part has been tested with daily use in rainy England for the past year and has been assembled by hand to ensure proper functionality.
Tools and materials
- 13 mm socket
- T25 Torx bit
- Trim tool
- 10 mm socket
- Adhesive (supplied)
Steps
Step 1
Flip up the wiper arm cover, then remove the nut with a 13 mm socket and lift off the rear wiper arm.
Step 1 
Step 1 
Step 2
Open the tailgate and remove the four T25 screws holding the interior trim.
Step 2 
Step 3
Pull all the interior tailgate trims off, unplug the wiper motor, then remove the three 10 mm nuts and lift the motor out.
Step 3 
Step 4
Remove the rubber grommet from the hole in the glass.
Step 4 
Step 5
Apply the adhesive around the hole in the glass and insert the blanking disc. Make sure you remove the protective film from the outside face of the disc.
Step 5 
Step 6
Clean the glass and you're done.
Step 6 