Skoda Fabia Mk4 Rear Wiper Blade Delete
Fits: Skoda Fabia Mk4
Please note we will not take responsibility for any damage caused during or after installation. This part has been tested with daily use in rainy England for the past year and has been assembled by hand to ensure proper functionality.
Tools and materials
- 13 mm socket and ratchet
- T25 Torx bit
- 10 mm socket
- MS adhesive (supplied)
Steps
Step 1
Flip up the cover on the wiper arm, loosen the 13 mm nut with a ratchet and lift the wiper arm off.
Step 1 
Step 2
Open the tailgate and remove the T25 screw in the grab handle on the interior trim.
Step 2 
Step 3
Release the clips all the way around the interior trim panel, working round the edge, then lift the panel away to get to the inside of the tailgate.
Step 3 
Step 4
Unplug the electrical connector from the wiper motor. Remove the three 10 mm nuts holding the motor in place and lift it out, then pull the rubber bung out of the hole in the glass.
Step 4 
Step 5
Apply the supplied MS adhesive around the hole in the glass and insert the blanking plug. Make sure you remove the protective film from the outside face of the plug.
Step 5 
Step 6
Clean the glass and you're done.
Step 6 